Troubleshooting - CEVIK PRO PE903XL Manual De Instrucciones

EN

TROUBLESHOOTING.

•
Irregular Darkening Dimming: Headband has been set unevenly and there is an
uneven distance from the eyes to the filter´s lens. Reset headband to reduce the
difference to filter.
•
Auto-Darkening filter does not darken or flickers: Front cover lens is soiled or
damaged. Change lens cover. Sensors are soiled. Clean the sensors Surface. Welding
current is too low. Adjust sensitivity to high.
•
Slow response: Operating temperature is too low. Do not use product at temperature
below 41ºF (5ºC).
•
Poor visión: Front/inside cover lens and or filters are soiled. Change lens. There is
insufficient ambient light. Shade number is incorrectly set. Reset the shade number.
•
Welding helmet slips: Headband is not adjusted properly. Readjust headband.
WARNING: Operator MUST STOP using the auto-darkening filter welding helmet
immediately if the above mentioned problems cannot be corrected. Contact your dealer.
•
In the event of a malfunction or breakdown, do not
attempt to repair it unless you have the appropriate
technical skills and tools. Contact one of our technical
services, which you will find on our website
www.grupocevik.es.
• Maintenance or repair performed by unauthorized
technical services
manufacturer's warranty.
22
will void and terminate the