Duronic BS503 Manual De Instrucciones página 6

4-2 Measuring
a) Place the scale on flat hard ground.
b) Stand on the platform to switch on the scale.
c) Step off of the scale and wait for 0.0 to show on the display.
d) Step back on the scale and stand still. The weight data will blink first, then
lock in place when stable. The scale will turn off automatically after about 10
seconds.
Note: If you want to measure once again, step off of the scale, then step on
the platform again.
5. Error Messages
5-1. Low battery indication. When "Lo" is shown, it means the battery is low.
The scale will turn off after a few seconds. You will then need to replace the
batteries.
5-2 Overload indication. When "Err" is shown, remove the weight from the
scale to protect the sensors.
6. Safety Instructions
6-1 Ensure the scale is on a flat, even and firm ground surface. Avoid carpet
or soft surfaces.
6-2 The surface of the scale will be slippery if wet. Please make sure both the
glass and your feet are dry before use.
6-3 This scale is not waterproof. Do not expose it to moisture.
6-4 Clean the scale with a slightly damp cloth, then wipe again with a dry
cloth. Do not use any chemical/abrasive cleaning agents to clean the scale.
6-5 If the scale is not being used for a long period of time, remove the
batteries before storing away.
6