FILLING PROCEDURE
CAUTION: The maximum fill amount is 1.7 gallons
(6.4 liters) of liquid. Do not overfill.
• Pre-mix the chemicals prior to adding them to the
tank. Do not mix chemical in the tank.
• Remove the cap by twisting counterclockwise.
• Pour liquid into the opening and secure the cap
back into place by twisting clockwise.
PLACEMENT DURING OPERATION
WARNING: DO NOT OPERATE FOGGER IN
ENCLOSED AREAS FOR MORE THAN 20 MINUTES.
CAUTION: DO NOT OPERATE FOGGER AT
TEMPERATURES AT OR BELOW FREEZING, AS THIS
MAY CAUSE AN ICY COATING WITHIN THE ROOM
AND/ OR DAMAGE THE FOGGER.
NOTICE: Never place the fogger directly on the
floor. Always elevate to keep dust and moisture from
entering the air intake of the fogger.
FOGGER OUTPUT ADJUSTMENT
• Open the adjustment knob one-quarter to one-half
turn, to deliver ULV fog. ULV fog produces small
droplets barely visible to the eye.
1
• Open the adjustment knob one full turn to deliver a
2
fuller, more visible mist.
Adjustment Knob Output Setting
¼ TURN OPEN
½ TURN OPEN
¾ TURN OPEN
1 TURN OPEN
SHUTDOWN PROCEDURE
CAUTION: Failure to follow this sequence can
result in liquid dripping into the hose and eventually
reaching and damaging the motor.
When fogging is finished, follow this sequence to turn
the unit off:
1. Turn the adjustment knob clockwise to the
closed (off ) position.
2. Shut off electric power. (Turn off the adjustment
knob before turning power off.)
3. Open the tank cap by twisting counterclockwise.
CARE AND MAINTENANCE
WARNING: RISK OF PERSONAL INJURY AND/OR
PROPERTY DAMAGE DUE TO CHEMICAL EXPOSURE.
• Always ensure that all chemical has been removed
from the fogger and the fogger has been cleaned
prior to performing any maintenance of filters.
• Always empty and flush the tank after each use;
never leave chemicals in tank for extended periods.
Dispose of chemicals according to chemical labels,
directions, and local governing bodies.
• Inspect the hose, and electrical cord, for wear and
damage.
• Protect the nozzle when not in use.
• Store the fogger in a well ventilated, dry
environment away from direct sunlight and out of
the reach of children.
• Do not attempt to disassemble or modify this unit.
• There are no user serviceable parts within this
fogger, other than the replaceable filter plate on the
bottom of the unit.
• Clean the filters on the bottom filter plate. Replace
the bottom filter plate if necessary in order to protect
the motor. You cannot replace only the filters. You
must replace the whole bottom filter plate assembly.
LOW
MEDIUM LOW
MEDIUM HIGH
HIGH
3