Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
1. Attach the two side panels by
screwing them into the LED light
assembly. Ensure that the panel with
the groove on the inside is fixed on
the left side (closest to control panel).
3. Place the base plate onto the
bottom of the panels and secure in
place with the screws. Make sure the
black cable is in the right position.
Then attach the feet to the base
plate.
5. Turn the unit the correct way up
and stand on a flat surface. Place the
water tank on the unit.

Set Up Instructions

2. Lay the LED light assembly upside
down on a flat surface and plug in the
black power cable into the jack. Then
thread the black cable into the groove
on the side panel towards the base.
4. Prepare the water tank by opening
up and taking out the accessories
inside.
6. Insert the white pump power cable
into the base plate jack. Then plug
in the power adapter into the LED
assembly jack.
9

Publicidad

Tabla de contenido
loading

Tabla de contenido