How To Use - Duronic DH20 Manual De Instrucciones

Figure 1
Note: Gently stretch the drainage pipe if it is squashed or twisted, otherwise
drainage will be restricted and the unit will not work normally. During the
operation, drainage pipe should never be in a higher position than the hose
connector.
1. ON/OFF: Press once to turn unit ON or OFF.
a. Press "ON/OFF" once and the unit will begin to work.
b. Press "ON/OFF" once again after use and the unit will shut down.
Note: Let the unit rest for about 3 minutes after turning off, so that residual
water on condenser can flow into the tank. Pull out the plug when the unit is
off for power saving and safety.
Take off plug

How To Use

14
Figure 2
Plug drainage pipe with
14mm inner diameter in
the hose connector