Duronic Si2 Manual De Instrucciones página 10

5. Iron your garment/fabric as you normally would.
6. If the water level goes low and you haven't yet finished ironing, unplug
the iron and refill it using the water jug provided. Then plug it back in and
commence with ironing.
7. When you have finished ironing, turn the control dial to the MIN position.
Unplug it from the mains socket.
8. Stand the iron on its heel and leave to cool down. Once cool, empty the
water tank.
9. To store away, wrap the cable around the iron. Store away using the bag
provided.
STEAM BURST FUNCTION
The steam burst function is mainly used for thick materials or fabrics with
stubborn creases.
If you want to use the steam burst function, you will need to set the control dial
to the MAX setting.
Press the steam burst button a few times before using the iron at each ironing
session. This will clean the steam vents.
Place the iron onto the fabric and press the steam push button to release a
powerful burst of steam. Wait a few seconds for the steam to penetrate the
fabric before pressing the button again.
10