SilverCrest SPMR 8000 A1
Maintenance/cleaning
Maintenance
Repairs are required when the PMR set has been damaged in any way, such as when liquid has
entered the product, the product has been exposed to rain or moisture, the product does not work
normally or the product has been dropped.
If you notice smoke or unusual noises or smells, unplug the charger cradle immediately or remove the
rechargeable battery or conventional batteries from the radio transceivers. In these cases the product
should not be used further and should be inspected by authorised service personnel.
All servicing work must be carried out by qualified specialist personnel.
Never open the housing of the handheld transceiver, as you may damage it.
Do not attempt to repair the product yourself.
If the power cord is damaged you run the risk of an electric shock.
Cleaning
Disconnect the PMR set from the mains before cleaning it.
Use a soft, lint-free cloth for cleaning.
Do not use any cleaners, detergents or solvents, as these may enter the housing and cause permanent
damage to the product.
For more stubborn dirt, use a slightly damp cloth.
Clean the battery terminals from time to time with a dry, lint-free cloth.
If a handheld transceiver gets wet, power it off immediately and remove the rechargeable or
conventional batteries. Dry the battery compartment with a soft cloth. Leave the battery compartment
open until the humidity has completely evaporated. Do not use the product until it is completely dry.
118 - English