Arrow ROT3200K-A Instrucciones De Uso página 13

WARNING! Always unplug rotary tool before changing
accessories and servicing your tool.
CAUTION Do not engage lock while the ROTARY TOOL
is running.
PLACING ACCESSORIES INTO THE TOOL
Always switch the tool off first. Hold the locking button at the
front of the tool down and undo the collet chuck
(anti-clockwise). Insert the collet that matches the shaft size
of the accessory to be used. Place the collet nut over the
collet and then insert the accessory shaft into the collet chuck
ensuring maximum shaft contact. Then tighten up the
collet nut.
COLLET NUT
To loosen, first press Shaft Lock Button and rotate the shaft
by hand until the lock engages the shaft preventing further
rotation.
CAUTION Do not engage lock while the ROTARY TOOL
is running.
With the shaft lock engaged use the collet wrench to
loosen the collet nut, if necessary, the collet nut must be
loosely threaded on when inserting an accessory. Change
accessories by inserting the new one into the collet as far as
possible to minimize runout and unbalance. With the shaft
lock engaged, finger tighten the collet nut until the accessory
shank is gripped by the collet. Avoid excessive tightening of
the collet nut when there is no accessory inserted.
ASSEMBLY
(DO NOT USE PLIERS).
COLLETS
Two different size collets to accommodate different shank
sizes are available for your Rotary Tool. To install a different
collet, remove the collet nut and remove the old collet. Insert
the unslotted end of the collet in the hole in the end of the
tool shaft. Replace collet nut on the shaft
1/8" Collet (Included and installed on the tool)
3/32" Collet (is included in the accessory kit)
Always switch the tool off first. Hold the locking button at
the front of the tool down and undo the collet chuck (anti-
clockwise). Insert the collet that matches the shaft size of the
accessory to be used. Place the collet nut over the collet and
then insert the accessory shaft into the collet chuck ensuring
maximum shaft contact. Then tighten up the collet nut.
CAUTION Always use the collet which matches the shank
size of the accessory you plan to use. Never force a larger
diameter shank into a collet.
To maintain balance on abrasive wheel points, before each
use, with the wheel point secured in the collet, turn on the
Rotary Tool and run the Dressing Stone lightly against the
revolving wheel point. This removes high spots and trues up
the wheel point for good balance.
WARNING! Only use accessories specifically
recommended for this tool. Others may be hazardous. Only
use accessories with Maximum Safe Operating Speed rated
at least equal to the maximum speed marked on the power
tool. This speed is based on the strength of the accessory,
13