Magnat MCD 550 Notas Importantes Sobre La Instalación / Certificado De Garantía página 11

REAR
1 MAINS CONNECTION
For connecting the supplied mains cable.
2 POWER SWITCH
Switches the device on and sets it in the standby mode. If the switch is set to the „OFF"
position, the device is disconnected from the mains supply.
3 DIGITAL AUDIO OUTPUT
For the connection of external devices (e.g. Minidisc recorder) via a coaxial digital output.
4 ANALOGUE AUDIO OUTPUTS
RCA output jacks for connection to a hi-fi audio amplifier.
INITIAL OPERATION
• Place the MCD 550 on an even surface. Observe the relevant clearance gaps as
specified under „Important safety instructions".
• Connect an audio output (analogue or digital) to a suitable amplifier. Also refer to the
operating instructions for the device when doing this.
• Connect the supplied mains cable to the rear and then insert the other end into a 230V
socket.
• Actuate the on/off switch on the rear side, the device is now in the standby mode.
• Switch on the device using the remote control or with the ON/STBY key on the front.
All manuals and user guides at all-guides.com
SERVICE AND TECHNICAL PROBLEMS
If you should encounter any technical problems, please contact your specialist dealer or
Magnat Audio-Produkte GmbH, Tel.: 02234807-0.
SPECIFICATIONS
Frequency response:
Signal to noise ratio :
Channel separation:
Output voltage:
Harmonic distortion:
Mains voltage:
Electricity consumption:
Playable formats:
Dimensions (wxhxd):
Weight:
Subject to technical change.
For further information please visit our website: http://www.magnat.de.
11
20 Hz – 20 kHz (+/- 0.5 dB)
105 dB (20 Hz – 20 kHz, A-weighted)
> 88 dB (1 kHz)
1.8 V
< 0.001%
220 – 240 VAC / 50 Hz
Max. 30 W
Standby <0.5 W
CD-Audio, CD-R, CD-RW, MP3, WMA
Main device: 430 x 62 x 287 mm
Main device incl. operational
elements/connecting terminals: 430 x 62 x 295 mm
Remote Control: 54 x 140 x 11 mm
3.0 kg