ANSMANN 1600-0254 Instrucciones De Servicio página 5

OPERATING INSTRUCTIONS
1. Front light
2. Charge socket
3. Switch
4. Main LED
5. Remaining capacity and charge LED display
6. Rear light
7. Main LED
8. Remaining capacity and charge LED display
9. Charge socket
10. Switch
11. Holder for the steering wheel slot
12. Micro-USB cable
FOR YOUR SAFETY
Read this manual carefully before using the product for the first time and
proceed accordingly. Keep this operating instructions for future use or for
the reference of future users. Failure to follow the operating instructions
and safety instructions may result in damage to the product and hazards
(injuries) for the operator and other persons.
The operating instructions refer to applicable standards and regulations of
the European Union. Please also adhere to the laws and guidelines specific
to your country.
SIGNS AND SYMBOLS
Please take note of the following symbols and words used in the operating
instructions, on the product and on the packaging.
= Information
Useful additional information about the product
= Caution
The caution warns you of possible damage of all kinds
= Warning
Attention – Danger! May result in serious injury or death
Class 3 equipment
Conforms to the European directive
Do not look into the lamp
Waste of Electrical and Electronic Equipment (WEEE Directive)
Read the operating instructions carefully before use!
OBSERVE SAFETY INSTRUCTIONS!
Avoid eye injuries - Never look directly into the beam of light or shine it into
other people's faces. If this occurs for too long, the blue light portion of the
beam can cause retinal damage. If the light beam shines into the eyes,
close the eyes and turn the head away from the light beam.
This lamp exceeds the conditions for risk-free use. The risk when using it
depends on how the user handles the lamp.
(1) This value indicates the factor by which the risk group limit value to the
next lowest group has been exceeded. The limit value is 1.
(2) Distance from eyes to the lamp at which the respective risk group is
applicable.
RISK GROUP 2
NOTE: Hazardous optical radiation may be omitted
by this product. When operating, do not look into
the lamp for an extended period of time. Can be
hazardous to the eyes.
Gefahrenwert der Exposition / Exposure Hazard Value (EHV)(1): 245.
Risk group Hazard Distance (HD)(2)
2 0m – 3,13m
1 3,13m – 31,3m
Free group > 31,30m
§ Read the operating instructions carefully before first use and then store
them safely.
§ Do not use the product if there is damage to the housing. Contact your
local authorised specialist or the service address of the manufacturer.
§ The product may only be charged in closed, dry rooms.
§ Use only a dry cloth for cleaning.
§ Do not open or modify the product! Repair work and replacement of the
rechargeable battery pack shall only be carried out by the manufacturer
or by a service technician appointed by the manufacturer or by a
similarly qualified person.
§ Keep the product and the packaging away from children. This product is
not a toy. Children should be supervised in order to ensure that they do
not play with the product.
§ This product is not to be used by persons (including children) who have
restricted physical, sensory or mental capabilities or who do not have
adequate experience and knowledge in handling this product. Such persons
must be instructed beforehand by a supervisory person who is responsible for
their safety or must be supervised during the use of the product!
§ All illuminated objects must be at least 10cm away from the light!
§ The LED cover must be kept clean.
§ The product may only be used for its intended purpose.
§ Do not use the product in potentially explosive areas or in the rain and
do not expose it to excessive heat.
§ Never submerge the product in water or other liquids.
§ Failure to observe the safety instructions can result in dangerous injuries
to persons or damage to the device!
FIRST USE
The on/off button for the front lamp is on the upper side of the housing:
§ Press briefly:
§ Press briefly:
§ Hold down:
The on/off button for the rear lamp is on the upper side of the housing:
§ Press briefly:
§ Press briefly:
CHARGING
Charge the product fully before using it for the first time. Likewise when
storing over an extended period of time, charge beforehand and charge at
least 2x per year during storage in order to prevent the rechargeable battery
pack deep-discharging.
To charge the front lamp, remove the sealing cap of the Micro-USB port; to
charge the rear light, remove the assembly rubber. To start the charging
process, connect the USB cable to the lamp and a USB charger (in that order).
LED STATUS INDICATION
The product has a professional LED charge level indicator and a capacity
indicator. When the battery is being charged, the display LED in the on/off
button flashes green. The display LED goes out as soon as the battery is fully
charged. The capacity indicator flashes if the battery is almost empty.
PROPER INTENDED USE
§ The lamps are designed to be used as a bicycle lighting system.
§ The lamps are not intended for any other applications.
§ Not suitable for household room lighting.
§ Suitable for extreme physical conditions.
ENVIRONMENTAL INFORMATION | DISPOSAL
The product should not be discarded in the normal household waste under
any circumstances. Dispose of the product via an authorised disposal centre
or your municipal waste disposal facility. Observe the current applicable
regulations. Contact your waste disposal facility in the event of any doubt.
Dispose of all packaging materials via an environmentally friendly disposal
facility. Used batteries and rechargeable batteries are special waste and
must be disposed of in accordance with national regulations and not with
the normal household waste.
LIABILITY DISCLAIMER
The information contained within these operating instructions can be
changed without prior notification. ANSMANN accepts no liability for direct,
indirect, incidental or other damage or consequential damage arising though
improper handling or through disregard of the information contained within
these operating instructions. We accept no liability or warranty claims or
guarantee claims in the event of incorrect use of the light.
GUARANTEE INFORMATION
The product has a two year guarantee. The guarantee does not apply to
damage to the device arising through a failure to comply with the operating
instructions.
Subject to technical changes.
MA: 1600-0254/V1/07-2018
Activation - 100%
Switching between 50% and 100% lighting power
Deactivation
Switching on
Deactivation
We assume no liability for printing errors.