Wireless > Basic Wireless Settings; Wireless Settings - Linksys AC2400 Guia Del Usuario

Linksys E-Series
PPTP
Point-to-Point Tunneling Protocol )PPTP( is a service that generally applies to
connections in Europe. If your PPTP connection supports DHCP or a dynamic IP
address, then select Obtain an IP Address Automatically. If you are required
to use a fixed IP address to connect to the Internet, then select Specify an IP
Address and configure the options below.
L2TP
Layer 2 Tunneling Protocol )L2TP( is a service that generally applies to
connections in Israel.
Telstra Cable
Telstra Cable is a service that generally applies to connections in Australia.
Connect on Demand or Keep Alive
The Connect on Demand and Keep Alive options let you choose whether
the router connects to the Internet only as needed )useful if your ISP charges
for connect time(, or if the router should always be connected. Select the
appropriate option.
Wireless > Basic Wireless Settings
The basic settings for wireless networking are set on this screen.
Note
After you set up the wireless network)s(, set up the wireless security
settings.

Wireless Settings

Network Mode—Select the wireless standards your network will support.
• Mixed—If you have Wireless-N )2.4 GHz(, Wireless-G, and Wireless-B devices
in your network, keep the default, Mixed.
• Wireless-B/G Only—If you have both Wireless-B and Wireless-G )2.4 GHz(
devices in your network, select Wireless-B/G Only.
• Wireless-B Only—If you have only Wireless-B devices, select Wireless-B
Only.
• Wireless-G Only—If you have only Wireless-G devices, select Wireless-G
Only.
• Wireless-N Only—If you have only Wireless-N )2.4 GHz( devices, select
Wireless-N Only.
• Disabled—If you have no Wireless-B, Wireless-G, and Wireless-N )2.4 GHz(
devices in your network, select Disabled.
Note
You may select Mixed, Wireless-A/N Only or Disabled for the
5 GHz band.
If you are not sure which mode to select, keep the default, Mixed.
Advanced Configuration
5