Operating The Unit; Radio Operation - Denver TCM-381 Manual De Instrucciones

OPERATING THE UNIT

1. Put through the power, then turn on the main switch of the unit.
2. When push the function switch CD//TAPE/OFF//RADIO to TAPE/OFF position the unit will be
on standby mode, meanwhile the indicator of POWER is off. When push the switch to the CD
position, the unit will be switched on, and you can appreciate MP3 or listen to CD, meanwhile
the LED indicator will light on. To RADIO position you can receive the broadcast with AM or
FM band and the POWER indicator is lighting.

RADIO OPERATION

Set the FUNCTION switch to RADIO.
FM
Select the FM or FM STEREO by BAND switch. Turn the TUNING knob to select the require station.
The FM stereo LED indicator will light on when a stereo broadcast is being received. Fully extend
the FM antenna and adjust its direction for best FM reception.
AM
Select AM by BAND switch. Turn the TUNING knob to select the require station. For operation on
AM the set contains a built-in ferrite aerial which is directional. Therefore, the set should be
positioned for the best signal strength.
FM Antenna
FM antenna rod for better FM reception
CASSETTE OPERATION
Playing Of Cassette
When playing of cassette, open the cover of the CASSETTE BUTTON DOOR first.
Be sure to tighten any slack tape in the cassette before use. Using either a pencil or a ball-point
pen, simply insert the pen or pencil into the center of the spool and rotate to remove slackness.
Depress the CASS. STOP / EJECT button to open the cassette door.
Insert the cassette into the compartment with the open end facing upwards and full reel on the
left hand side, push the cassette well down and close the door. Be sure not to touch the tape
surface. Select "TAPE" on the FUNCTION switch and press the PLAY button. To stop playback,
press the CASS. STOP / EJECT button once. To release the cassette, press the CASS. STOP /
EJECT button again.
Recording From Radio
Set the FUNCTION button to RADIO select AM or FM on TUNER / BAND button and press to the
desired broadcast (refer to radio operation section). Insert a cassette into the deck and press the
RECORD button.
Press the CASS. STOP / EJECT button to stop recording. The CASS. PAUSE button can be used to
stop recording for short intervals. Press the CASSETTE F.FWD to fast forword the tape, press the
CASSETTE REWIND button to fast rewind the tape.
Recording From CD
Set the FUNCTION to CD. Select the required tracks to be recorded. Insert a cassette into the
cassette deck and press the CASS. RECORD button.
Press the CASS. STOP / EJECT button to stop recording.
All manuals and user guides at all-guides.com
UK-3