Safety Informations; Air Source - BGS technic 3218 Manual De Instrucciones

SPECIFICATION
Oscillation:
Air inlet:
Air hose (ID):
Air consumption (Avg):
Working pressure:
Noise level:
Vibration:
Weight:
WARNING!
Read and understand and follow all instructions and warnings before operating this tool.
Failure to do so may result in personal injury and/or property damage and will void warranty.

SAFETY INFORMATIONS

•
Use proper air pressure and CFM rating listed for this tool.
•
Be sure air is in OFF position when connecting tool to air supply.
•
Always wear approved eye protection when using tools. If raising dust, wear a suitable mask.
•
Use only accessories that are designed for use with air tools.
•
Be sure to disconnect tool from air supply before changing accessories, performing service on
tool, and when not in use.
•
As with any tool, use common sense when operating. Do not wear loose clothing or jewellery
that could become caught by moving parts, causing injury. Operate tool a safe distance from
yourself and others in the work area.
•
Follow air source manufacturer's directions for connection of regulators, filters, and other
accessories to air source.
•
Keep children and other unauthorized persons away from the work area.
•
Do not allow children to play with the tool or its packaging.
Main Applications
This tool is perfect for scraping out plastic or rubber protuberance from a mineral / metal material
surface.

AIR SOURCE

Clean air of correct air pressure is recommended for the power supply for this tool. A maximum of 90
PSI at the tool is recommended for most air tools of this class. Check specifications section for
recommended pressure. (Depending on length of air hose and other circumstances, air pressure at
compressor may need to be increased to 100 PSI to ensure 90 PSI at the tool.) Water in the air hose
and compressor tank contributes to reduced performance and damage of the air tool. Drain the air
tank and filters before each use and as necessary to keep the air supply dry. Hose length over 25"
causes loss in line pressure. Increase hose ID or increase compressor pressure to compensate
pressure loss. Use an in-line pressure regulator with gauge if air inlet pressure is critical.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Air Window Seal Cutter
20.000
1/4" (6,3 mm)
3/8" (10 mm)
4 cfm
90 psi (6,2 Bar)
LpA 80.5 dB (A)
LwA 91.0 dB (A)
ahd = 5.04 m/s²
K = 0.16 m/s²
1300 g
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 3218
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed