Installing Your Refrigerator; Unpacking Your Refrigerator; Proper Air Circulation; Electrical Requirements - Summit CM40WH Manual Del Usuario

All manuals and user guides at all-guides.com
English

Installing Your Refrigerator

Unpacking Your Refrigerator

1. Remove all packaging material. This includes the foam base and all
adhesive tape holding the refrigerator accessories inside and
outside.
2. Inspect and remove any remains of packing, tape or printed
materials before powering on the refrigerator.

Proper Air Circulation

designed for, you should install it in a location where there is proper air
circulation, plumbing and electrical connections.
Sides...............3/4" (19mm)
Top....................2" (50mm)
Back..................2" (50mm)
Electrical Requirement
with proper grounding to power the refrigerator.
in order to accommodate a two plug outlet. This is a dangerous practice
since it provides no effective grounding for the refrigerator and may
result in shock hazard.

Use of Extension Cords

under certain conditions. If it is necessary to use an extension cord,
use only a 3-wire extension cord that has a 3-blade grounding plug
and a 3-slot outlet that will accept the plug. The marked rating of the
extension cord must be equal to or greater than the electrical rating of
the appliance.

Install Limitations

heated e.g. garage etc. Your refrigerator was not designed to operate
in temperature settings below 55˚ Fahrenheit.
away from direct sunlight or heat source e.g. radiators, baseboard
heaters, cooking appliances etc. Any floor unevenness should be
corrected with the leveling legs located at the bottom.
counterclockwise to raise the refrigerator and clockwise to lower it.
5