Kichler 49984DBK Instrucciones De Instalación

Fixture Diagram
Parts List
[A] Mounting [C] Mounting
Strap
[B] Outlet Box
Cautions
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main
fusebox before starting and during the installation.
WARNING:
This fixture is intended for installation in accordance
with the National Electrical Code (NEC) and all local code
specifications. If you are not familiar with code requirements,
installation by a certified electrician is recommended.
Installation Instructions
1) Attach mounting strap[A] to outlet box[B] using the
mounting strap screws[C].
2) Grounding instructions: (See Illus. a or b).
a) On fixtures where mounting strap is provided with a
hole and two raised dimples, wrap ground wire from
outlet box around green ground screw, and thread
into hole.
b) On fixtures where a cupped washer is provided,
attach ground wire from outlet box under cupped
washer and green ground screw, then thread into
mounting strap.
If fixture is provided with ground wire. Connect fixture
ground wire to outlet box ground wire with wire
connector (Not provided) after following the above steps.
Never connect ground wire to black or white power
supply wires.
a
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
GREEN GROUND
SCREW
[D] Mounting
Strap Screws Screws
[E] Canopy
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
E
C
D
Installation Instructions (continued)
3) Make wire connections. Reference chart below for
correct connections and wire accordingly.
Connect Black or Red
*Parallel cord (round &
Clear, Brown, Gold or
than green) with copper
*Note: When parallel wire (SPT
1 & SPT 2) are used. The neutral
wire is square shaped or ridged
and the other wire will be round
in shape or smooth (See illus.)
4) Push fixture to wall. Be sure not to pinch wires between
wall and canopy of fixture. Thread mounting screws[D]
into threaded holes on the long sides of the canopy[E].
5) Insert recommended bulb(s) (Not supplied).
INSTRUCTIONS FOR MOUNTING FIXTURE OUTDOORS AND/
OR IN WET LOCATIONS.
6) Mounting surface should be clean, dry, flat and 1/4"
larger than the canopy on all sides. Any gaps between
the mounting surface and canopy exceeding 3/16"
should be corrected as required.
7) With silicone caulking compound, caulk completely
around where back of canopy meets the wall surface to
b
prevent water from seeping into outlet box.
FIXTURE
GROUND
CUPPED
WASHER
We're here to help
A
Supply Wire to:
Black
smooth)
Black without Tracer
Insulated wire (other
conductor
866-558-5706
Hrs: M-F 9am to 5pm EST
B
Connect White Supply
Wire to:
White
*Parallel cord (square &
ridged)
Clear, Brown, Gold or Black
with Tracer
Insulated wire (other
than green) with silver
conductor
Neutral Wire
IS-49984-US