Walter BIO-CIRCLE MINI Manual Del Usuario página 9

2. Position 3-way Control Valve (B) toward desired direction of solution flow.
Solution can flow through both the flexible faucet (A) and the flow-through brush
(C) simultaneously when the handle is positioned mid-way between the two.
3. Turn the cleaning pump ON & OFF by pressing ON/OFF switch (E).
To minimize fluid consumption, always turn the cleaning pump OFF after use
by pressing the pump switch (E) again.
Wet the sink, parts to be cleaned and any brushes prior to cleaning; this will
prevent grease and dirt from sticking to the surfaces.
The BIO-CIRCLE™ unit is supplied with an efficient multi-jet flow-through
brush, which is well suited for most cleaning applications. However, for best
results, when cleaning smaller or intricate parts, it is recommended to run
the cleaning solution through the flexible faucet (A) and use brushes that are
well adapted to the shape of the part being cleaned. Always clean parts while
holding them under the flow of liquid.
4. For optimum performance, always keep unit topped-up to the proper
working level of at least 80 L/21 gal., do not fill above the MAX level. Do not
allow solution level to fall below 55 L/15 gal. Observe fluid level lines molded
into the tank wall.
When the solution level falls below minimum, the float switch will cut power to
the cleaning pump and the heater coil. The air pump, however, will continue
running. Check the fluid level every other week and top-up to operating
level.
Note: The cleaning pump will start automatically after the fluid level has been
topped up if the cleaning pump switch (E) is in the ON position. To prevent spills,
always put switch (E) in the OFF position when the float switch has cut power to
the cleaning pump.
All manuals and user guides at all-guides.com
90 L
75 L
60 L
9