vitapur GWF3 Manual De Uso Y Cuidado página 2

Operating Instructions
With clean hands:
1. Remove Long Life Replacement Filter from plastic wrap.
2. Soak the long-life filter in cold tap water for 30 minutes before using.
3. Once filter has soaked for 30 minutes, flush the filter under the tap for 30
seconds and shake gently.
UPPER CHAMBER ASSEMBLY OF YOUR GWF8
1. When replacing the long-life filter, you should wash
and rinse out the entire water filtration system.
2. Align the two ports and locking tabs at the bottom of
the pre-filter with the holes in the upper chamber of
the filtration system and snap it into place.
3. Twist the soaked filter onto the base of the upper
chamber of the filtration system. Securely tighten the
filter to the housing to make a tight seal for effective
filtration.
4. Re-attach lid to ring on the upper chamber.
5. You can now place your assembled upper chamber on
top of the lower chamber.
MANUAL FILTER CHANGE REMINDER
To use the manual filter change reminder, turn the dial on
the lid until the number in the green circle coincides with
the month that the filter is being installed. The number that
appears in the red circle will be the month to replace your
filter. Repeat above step for every filter change.
Helpful Tips
1. Keep your water filtration system in a dry place and out of direct sunlight.
2. Your Vitapur® Long Life Replacement Filter will last up to 6 months and filter over
800 liters (211 gallons) of water.
3. If the water filtration system has not been used for an extended period of time,
please replace the long-life filter and wash top and bottom chambers.
4. When replacing the long-life filter, you should wash and rinse out the entire water
filtration system.
5. Use only Vitapur® approved Long Life Replacement Filters (GWF3).
Tested and certified by CSA Group
to the requirements of NSF/ANSI
Standard 42 and CSA B483.1 for the
reduction of chlorine, taste and odor.
Drinking Water
www.ghpgroupinc.com
Customer service: 1-877-447-4768