Safety 1st Star 08232 Guia Del Usuario página 7

Installing Your Monitor
To Set Up the Baby's Unit:
CAUTION
• When using batteries, check batteries regularly. Battery indicator will show one
block and the icon will flash when the battery is almost empty and requires
charging. DO NOT use monitor system in portable mode when batteries are low.
WARNING
• To prevent entanglement, only mount the Baby's Unit in a location where it and its
AC adapter cord are OUT OF REACH OF CHILDREN.
• DO NOT mount the Baby's Unit directly above heating vents, other heat producing
sources or in direct sunlight.
• To prevent entanglement and overheating, NEVER use an extension cord.
NOTE: The Baby's Unit may use either the AC adapter or
4 AA batteries (not included). When plugged in, the AC
adapter will be the source of power. AC adapter will not
charge batteries if Rechargeable batteries are used.
5. For AC Power Use: Locate the Baby's Unit and its
AC adapter. Connect the AC adapter into the side of
the Baby's Unit (Figure 4). Connect the AC adapter
into a power outlet. Place the Baby's Unit on a flat sur-
face 4 to 6' (1.5 to 2 m) away from the baby.
CAUTION: DO NOT use an adapter that did not
come with this product.
6. For Battery Use: Using a coin or flathead screwdriver
to unscrew the lock at the back of the Baby's Unit
(Figure 5). Pull off the battery door. Insert
four AA batteries (with polarity as
shown).
Secure the door with the lock.
4
Baby's
Unit
AC Adapter
4 AA
5
Batteries
INSTALLATION REF.: 4358-4037A
7