JVC TS-C50P2G Instrucciones De Montaje página 40

3. Prepare the Wide Plasma Display.
• Attach the insulating spacers to the display.
Remove the four bolts.
N o t e
Note
• Place the display face down on top of a cloth which is clean and free from other foreign particles, and then carry out the
procedure above.
4. Install the display to the wall-hanging bracket.
N o t e
Note
• Do not Iift the display too high, otherwise it may become unhooked.
All manuals and user guides at all-guides.com
Notches (for hanging horizontally)
Insulating spacer
1. Remove the four bolts from the display.
2. Use the accessory tool (Allen key) to
install the four accessory pan head
bolts with hex socket, toothed pan
washers and insulating spacers into the
holes where the four bolts used to be
as shown in the illustration.
Pan head bolt with hex socket
Toothed pan washer
Insulating spacer
Installation procedure
Push the upper insulating spacers
on the display into the notches at
the top of the wall-hanging bracket
until they are hooked in, and then
lower the display into place.
While lifting the display slightly,
insert the lower insulating spacers
on the display into the lower
horizontal hanging holes in the wall-
hanging bracket, and then lower the
display.
11