HOLZMANN MASCHINEN BS 115N Manual De Instrucciones página 4

1.1.2 Adjusting the vertical bandsaw blade guide for clippings
Slightly loosen the left bandsaw blade
guide with the screw for fixation.
The tolerance by lowering the bandsaw blade guide leveling on bearing roll on the bandsaw
blade to zero.
Slightly loosen the nuts on either side guide
rollers with a wrench SW17.
HOLZMANN Maschinen Austria  www.holzmann-maschinen.at
Bedienungsanleitung Metallbandsäge BS 115N
With a wrench SW 12 is with the help of the
eccentric bearing roller according to externally
or internally displaced.
Repeat on both sides of the process until no play
between the bearing rollers.
The bandsaw blade should be centered on the
upper bearing role.
CAUTION: The two lower side rollers do not
clamp!
PRODUKTBEOBACHTUNG
Metallbandsäge
Seite 4
BS 115N