LumaPro Dualbrite 2LBN5 Manual De Instrucciones Y Partes página 2

INSTALLATION
For easy installation, select an existing light with a wall
switch for replacement.
For best performance, mount the fixture about 8 ft. (2.4 m)
above the ground. NOTE: If fixture is mounted higher than
8 ft. (2.4 m), aiming the sensor down will reduce coverage
distance.
Wall Mount
CAUTION: For under eave installation, the
sensor head must be rotated as shown in the next
two steps for proper operation and to avoid the risk of
electrical shock.
For eave mount only:
❒ Swing the sensor head towards the clamp screw.
Clamp Screw
❒ Rotate the sensor head clockwise 180° so the
controls face down.
Controls
Controls
If the sensor pops out of the ball joint, loosen the
clamp screw and push the sensor back into the ball
joint. Tighten the clamp screw when done.
Wire the Light Control
WARNING: Turn power off at the fuse or circuit
breaker.
1. Remove the existing light fixture.
2. Install the mounting strap as shown using two screws
that fit your junction box.
3. The plastic hanger can be used to hold the fixture
while wiring. The small end of the plastic hanger
can be threaded through the hole in the center of
the cover plate. The small end then goes into one
of the slots on the mounting strap.
All manuals and user guides at all-guides.com
4. Route the light control's wires through the large
5. Twist the junction box wires and fixture wires together
Mounting
Eave Mount
1. Align the light control cover plate and cover plate
Controls
2. Align the three slots in the decorative shell with the
3. Push the rubber plug firmly into place.
4. If a wet location junction box was not used, caulk
5. Adjust the lamp holders by loosening the lock nuts
-2-
gasket hole.
as shown. Secure with a wire connector.
Black to
Strap
Black
Junction box ground wire to
green ground screw on fixture.
Mount the Light
gasket. Secure with the mounting bolt.
lamp holder pins. Push the shell in and then twist
clockwise to lock. Repeat for other shell.
Shell Slot
the wall plate mounting surface with silicone weather
sealant.
To avoid water damage and
electrical shock, keep lamp
holders 30° below horizontal.
Lock Nut
Lens
but do not rotate the lamp holders more than 180°
from the factory setting. When screwing in the
floodlamps, do not overtighten.
White to
White
Rubber
Plug
Mounting
Bolt
Gasket
Keep lamps at least
1" (2.5 cm) from the
sensor. Do not allow
the lamps to block
the lens.
598-1010-05