TFA_No. 50.2003_Anleit_09_21
11.09.2021
Digital kitchen scale
Thank you for choosing this instrument from TFA.
1. Before you use this product
• Please make sure you read the instruction manual carefully.
• Following and respecting the instructions in your manual will prevent damage to your instrument and
loss of your statutory rights arising from defects due to incorrect use.
• We shall not be liable for any damage occurring as a result of non-following of these instructions.
Likewise, we take no responsibility for any incorrect readings or for any consequences resulting from
them.
• Please pay particular attention to the safety notices!
• Please keep this instruction manual safe for future reference.
2. Delivery contents
• Digital kitchen scale
• Battery 1x CR2032
• Instruction manual
3. Range of application and all the benefits of your new instrument at a glance
• Scale with LCD display
• Slim-line – only 15 mm
• Comfortable sensor touch operation
• Automatic off-function
• Tare function
• Non-slip stand with 4 rubber pads
• With support for wall mounting (fold out)
4. For your safety
• This product is exclusively intended for the range of application described above. The product should
only be used as described within these instructions.
• Unauthorized repairs, alterations or changes to the product are prohibited.
• Keep away the scale from heat sources (like: stoves).
• Do not overload the scale (max. 5 kg).
Caution!
Risk of injury:
• Keep this device and the battery out of reach of children.
• Small parts can be swallowed by children (under three years old).
• Batteries contain harmful acids and may be hazardous if swallowed. If a battery is swallowed, this can
lead to serious internal burns and death within two hours. If you suspect a battery could have been swal-
lowed or otherwise caught in the body, seek medical help immediately.
• Batteries must not be thrown into a fire, short-circuited, taken apart or recharged. Risk of explosion!
• Low batteries should be changed as soon as possible to prevent damage caused by leaking.
• Avoid contact with skin, eyes and mucosa when handling leaking batteries. In case of contact, imme-
diately rinse the affected areas with water and consult a doctor.
Important information on product safety!
• Do not expose the device to extreme temperatures, vibrations or shocks.
• Protect it from moisture.
8
17:21 Uhr
Seite 5
Digital kitchen scale
5. Elements (Fig. 1+2)
A 1: Weight display
A 3: UNIT convert button
A 5: Support for wall mounting (fold out)
6. Getting started
• Open the battery compartment and remove the battery insulation strip.
• Close the battery compartment again.
• All segments will be displayed briefly. 0 g (default) appears on the display.
• The scale is now ready to use.
7. Setting of the weight unit
• Press the UNIT button and change between g =>lb:oz, lb:oz=>oz, oz=>ml, ml=>g as the desired weight
unit.
8. Use of the scale
• Place the scale on a flat solid surface.
• In order to switch on the scale, press the ON/OFF TARE button.
• All segments will be displayed briefly.
• An soon as "0" appears on the display you can start to weight.
• Place the weight in the middle of the surface.
• To switch off the instrument, press and hold the ON/OFF TARE button for two seconds.
• When the scale is not used, it will automatically switch off after approx. 2 minutes.
9. Tare function
• If you use a bowl for measuring, please put at first the bowl on the platform and then turn on the scale
with the ON/OFF TARE button. Is the scale already in use, press the ON/OFF TARE button to reset the dis-
play to "0" .
• If you want to measure more than one ingredient in the same bowl, press the ON/OFF TARE button before
you put the new ingredient into the bowl. The display always goes back to "0" and you can continue the
measuring process without problems.
10. Care and maintenance
• Clean the device with a soft damp cloth. Do not use solvents or scouring agents.
• Remove the battery if you do not use the device for a long period of time.
• Keep the device in a dry place.
10.1 Battery replacement
• Change the battery when the empty battery symbol appears on the upper left display edge or "Lo".
• Open the battery compartment and insert a new battery CR2032.
• Make sure the polarities are correct (+pole above).
• Close the battery compartment again.
11. Troubleshooting
Problem
Solution
➜ Press the ON/OFF TARE button to switch on the instrument
No display
➜ Ensure that the battery polarity is correct (+pole above)
➜ Change the battery
A 2: ON/OFF TARE button
A 4: Battery compartment
9