Battery Installation - General DTC500 Manual Del Propietário

DTC500 Manual -FINAL-91307
NAME AND FUNCTIONS OF BUTTONS:
Press Functions
SET Zone 1
+ 1 step forward
Alarm 1, 2 on/off
- 1 step backward
CLEAR Clear memory for
Max/Min display
ALARM Read alarm time 5 sec in normal mode
MAX/MIN Read maximum/minimum record 5 sec
ALERT Temp alert on/off
CHANNEL Select Channel 1,2,3,
auto scroll
SNOOZE Trigger snooze alarm

BATTERY INSTALLATION

HOME RECEIVER:
Lift off the battery cover at the back, install 2 "AA"
batteries according to the polarity indicated, close the
battery cover.
REMOTE SENSOR:
Lift off the bracket stand, loosen the 4 screws with a
small screwdriver, insert 2 "AAA" batteries according to
the polarity indicated. Replace the cover and tighten the
4 screws.
SETTING UP THE
WIRELESS THERMOMETER
• For the first installation, always insert batteries to the
home unit and then the remote sensors. Your new
RF Thermometer is built with random security code
technology. The home unit will learn the random code
of the first remote sensor and log in as Channel 1.
Channel 2 and Channel 3 will be registered in the
same way.
• A registered channel will not accept any new sensors.
The registered channels will be erased when the
batteries of the remote sensor or the home unit are
removed.
• When replacing batteries for the remote sensor,
remember to clear the corresponding channel of the
home unit by removing the batteries or in the
following way: Select the respective channel by
pressing the CHANNEL button, hold the CHANNEL
button 3 seconds to clear the registration.
9/13/07 4:29 PM
Hold 3 seconds
Enter clock &
calendar setting
Fast advance
Fast backward
Manual
synchronization
Alarm time
setting
Enter temp
alert setting
Delete
current channel