Logic3 i-Station Studio Manual Del Usuario página 4

Remote Control
Mute Control
1. Press the 'MUTE' button on the remote control, the audio music will switch off and the MUTE indicator will
appear on the front display.
2. To cancel the Mute function and restore the music press the MUTE button again or press the VOLUME + -
buttons on the unit or the remote control. The MUTE indicator will disappear.
Bass and Treble
1. Press the Bass + or – buttons on the remote control to adjust the bass level of the unit, the bass level
ranges from -6 to +6. The Bass level will default to 0 if the power is disconnected.
2. Press the Treble + or – buttons on the remote control to adjust the treble level of the unit, the treble level
ranges from -6 to +6. The Treble level will default to 0 if the power is disconnected.
Headphone
The MIP199 has a line out connection at the back of the unit, to allow you to connect headphones resulting in no
audio output from speakers at the front of the unit
Note : Always adjust the volume level to the minimum level before connecting your headphones into the system,
then adjust the volume level to your preference
Dimmer Control
The MIP199 has a 4 level dimmer for the front display when the unit is active. To control the brightness of the light
press and hold the 'DIMMER' button on the remote control.
iPod synchronization
The MIP199 offers the facility to allow data synchronization to your iPod by using iPod 30pin to USB Cable (not
supplied).
1. Connect a iPod 30 pin cable into the 30 pin dock connection port on the back of the MIP199.
2. Connect the USB connector to an available USB port on your PC.
3. The iPod will now be recognized as an external device to allow you to synchronize your iPod
Safety information
This lighting flash arrow symbol in a triangle alerts users to the
presence of non-insulated high voltage within the product's enclosure
that present an electrical shock hazard.
The exclamation point symbol in a triangle alerts users to the presence
of important operating and maintenance instructions in the literature
accompanying this product.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Should you have any connection or setup problems with the Logic3 MIP199 please contact our Technical Support
Hotline on +44 01923 471 000– National call rates apply or E-mail
All manuals and user guides at all-guides.com
support@logic3.com