Dremel 3D40 Traducción De Las Instrucciones Originales página 19

FIG. 2
40 Lid for
filament
n on
clockwise 5. Thread tip of new filament through guide tube,
nt, see
6. If changing existing filament, 3D40 will
7. When Feed Filament screen appears, tap "Next" on
8. Filament will be drawn into the extruder and begin
All manuals and user guides at all-guides.com
place spool on spool holder, replace spool door by
aligning locking tabs and rotating clockwise, see
figure 1.
Tap "Next" on touchscreen.
automatically purge existing filament.
touchscreen and thread filament coming from guide
tube into extruder intake until extruder feeds
through on its own, see figure 2.
to exit from the hot extruder tip.
NOTE: Your Dremel 3D40 was tested by building
objects before leaving the factory. These test
objects may have been made with a different
filament color than you are using. Therefore, a
small amount of filament may be remaining in the
extruder.
Guide Tube Filament
9. When new filament appears from extruder tip, tap
"done" on touchscreen to complete filament load
process, return to main menu, and calibrate
extruder. Carefully remove excess filament without
touching hot extruder tip. If necessary, carefully
remove debris from extruder tip with needle nose
pliers.
WARNING
!
WHEN CLEARING DEBRIS. DREMEL 3D40 WILL NOT
WORK PROPERLY WITH A DAMAGED EXTRUDER TIP
AND WILL REQUIRE REPLACEMENT.
10. Close 3D40 lid and door.
19
Filament Guide Extruder intake
USE EXTRA CARE NOT TO
DAMAGE THE EXTRUDER TIP