Mounting And Cleaning Pad; Neutralizing - Walter Surface Technologies MINI SURFOX Manual De Usuario

6
Start-up procedure
B) Mounting and cleaning pad
Squeeze and insert clamp ring
Insert cleaning pad
Press in wand tip
Remove tip with installed pad
10
All manuals and user guides at all-guides.com
7

Neutralizing

Neutralizing
The SURFOX-N liquid is a specially formulated cleaner
and neutralizer for the SURFOX electrolyte solutions. It is a
powerful ready-to-use formula which leaves no residue, is
non-toxic, solvent free, water-based and biodegradable.
Directions for cleaning and neutralizing
SURFOX electrolyte cleaning solutions:
1. Remove any excess SURFOX-T electrolyte solution
using a soft clean cloth. (This step is not required with
SURFOX-G)
2. Spray SURFOX-N on the surface.
3. Wipe dry with a SURFOX POWERCLOTH.
For more information about this product, refer to product
MSDS.
WARNING! When using SURFOX-T, be sure to wipe off all
excess from the surface and clean/neutralize to prevent salt
residues.
Clean the weld using the SURFOX machine and SURFOX
electrolyte solutions. Work only 2 feet at a time.
Note: the cleaning pad/brush should be kept moist –
not dripping .
1. After weld cleaning, use a clean cloth or paper towel
and wipe the affected area in a squeegee action from left
to right. Then discard the cloth or paper towel. (This step
is not required when using SURFOX-G)
After cleaning the weld with the SURFOX weld cleaning
machine, the electrolyte solution must be cleaned and
neutralized.
1. Spray the affected area with SURFOX-N cleaner and
neutralizer. Allow to sit for 15 seconds on the surface.
2. Use a SURFOX POWERCLOTH and wipe the affected
area in a squeegee action from left to right.
Note: failure to neutralize or neutralize properly the
SURFOX-T electrolyte solution will result in clouding, hazing
and dulling of the surface.
SURFOX-T electrolyte
deposit due to unproper
neutralization and rinsing.