Water Tech VOLT Manual Del Operador página 4

English
Battery Box
1. Remove the set of 8 AA batteries
that are attached to the underside of
the unit.
2. Remove the 2 screws that hold
the cover of the battery chamber and
carefully remove the battery holder
that is attached to the wire terminal
connector.
Warning:
Do not mix old and new batteries.
Do not mix Alkaline, Carbon-Zinc, or
Ni-Cad batteries.
3. Install batteries into the holder as
shown. Assure the battery holder
and wire terminal are connected.
Orient the battery holder and wire
terminal to the right side of battery
compartment, as shown in Fig. 1.
4. Insert the batteries into the battery
chamber, as shown in Fig. 2 and Fig.
3.
5. The battery pack must sit deep
into the case. Not doing so will lead
to damaging leakage during use.
6. Place the rubber gasket on the
battery chamber cover, as shown
in Fig. 5.
7. Replace the battery chamber lid
and tighten the screws.
Caution:
DO NOT OVER-TIGHTEN
THE SCREWS.
SETTING UP THE VOLT LEAF VAC
3
Note:
While cleaning, leaves may settle around the propeller
reducing cleaning effectiveness. Should this occur, just
shake the Leaf Vac back and forth to dislodge the settling
leaves and continue cleaning.
Attaching the Pool Pole
Slide your pool pole on to the adapter until the plastic clip
snaps into place on the pole.
Pole Adapter
Secure the 2 grey pins to
fasten the adapter in place
as shown.
Debris Bag
1. Place the mouth of the
bag over the black collar on
the Leaf Vac.
2. Secure the bag in
place by squeezing the
spring-loaded plastic slide.
Pull on the cord until the
bag tighten beneath the
black collar.