Crosstour CR300 Manual Del Usuario página 11

.
In playback mode, short press OK Button to play current video file.
Note: If in video mode, please stop video recording first, and then press Mode
Button twice to switch to playback mode.
Instructions for menu setup
Video recording settings
After being powered on, it enters the video mode and automatically starts record-
ing. Short press OK Button to stop recording. Short press Menu Button to switch
to video recording settings. The screen displays the settings such as: resolution,
loop recording, WDR, exposure, motion detection, record audio, date stamp,
G-sensor. Short press Up/Down Button to switch to a setting option. Short press
OK Button to select the option.
Video resolution: 1080FHD 1920*1080， 720P 1280*720
Loop Recording: The cam will cyclically record new videos under the time interval
you set. Off / one minute / three minutes / five minutes. Default value: three minutes
WDR: off/ on. Default value: off.
Used to adjust the brightness of the video clips. Suitable for situations like low
light or back light.
Exposure: "+2.0","+5/3","+4/3","+1.0","+2/3","+1/3","+0.0","-1/3","-2/3","-1.0","-4/3","-5/3","-2.0"
(Default exposure value is 0.0)
Motion detection: on/off. Default value: off.
It starts recording once it detects moving subjects within 3 meters in front of the
lens, otherwise it stops recording. It automatically starts recording 10s video and
stops recording after no dynamic motion appears.
Record Audio: Choose to record audio or not in the video. On/off. Default value: on.
7