Storage After Use; Maintenance; Troubleshooting - Jetboil STASH Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
Usage:
1. If necessary, rotate control valve (7.1) clockwise to decrease flame
setting.
2. Once the burner is lit, carefully place the pot with its contents on
the burner base, centered on pot supports (Fig 9 & 10).
Use care when removing lid. Steam and/or contents may
CAUTION
be hot and can cause injury.
After Use:
1. Turn off control valve (7.1) (tighten clockwise) to extinguish flame.
2. Remove pot from burner base – hold pot by handle (9.1).
Exposed metal parts will be hot and may cause injury if
WARNING
touched.
3. Always disconnect fuel canister after use. Unscrew fuel canister
from burner base (Fig 4), and replace plastic fuel cap.
Always check that the burner is extinguished before
WARNING
disconnecting the fuel canister. Vapors can ignite and
cause serious injury.
Packing:
1. Allow stove, pot, and lid to fully cool and dry before packing.
2. Remove stabilizer from canister and fold for storage (2.3).
3. Fold pot support legs (2.4).
4. Fold Valve bail under valve body (2.1).
5. Refer to Figs 11 through 14 for packing contents into pot.

Storage After Use:

1. Always disconnect fuel canister before storing the stove.
2. Ensure stove and pot are clean and dry before storing.
3. Store the stove in a cool, dry location, indoors.

Maintenance:

1. Flame Check (Every use): The height of the flame should increase
from low to high with counter-clockwise rotation of the control
valve. Flame should be blue with no yellow tipping at full output.
Flame should not flash back into burner or lift off of burner top. If
flame abnormalities are found, see your dealer or contact Jetboil for
service.
2. Cleaning Pot (before storage, or as needed): Allow pot to cool
before cleaning. Do not use a dishwasher or abrasive compounds
(sand, salt, etc.) to clean. Only wash by hand with soapy water.

Troubleshooting:

1. Flame does not extinguish: Tighten valve as much as possible, blow
out flame, and immediately detach fuel source. See your dealer or
contact Jetboil for service.
2. If an issue cannot be corrected using these instructions, see
Limited Warranty on back page.
8

Publicidad

Tabla de contenido
loading

Tabla de contenido