IMPORTANT SAFETY INSTRUCTIONS AND DANGER WARNINGS
Accordance with the requirements of CE standard
Class II protection without earth connection
The product is for indoor use only
•
Read all safety and operating instructions prior to using the device for the first time and keep them for future
reference.
•
All warnings on the device and in the operating instructions should be adhered to.
•
Unplug the device from the wall outlet before cleaning. The device should be cleaned only with a dry cloth.
Avoid solvents or other cleaning detergents.
•
Do not use the device near water for example, near a bath tub, wash bowl, kitchen sink, or laundry tub, in a
wet basement, or near a swimming pool and the like.
•
Ventilation slots and openings in the cabinet are provided for ventilation and to ensure reliable operation by
avoiding overheating. These openings must not be blocked nor covered.
•
Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed
upon or against them. Pay particular attention to cords at plugs, convenience receptacles and the point
where they exit from the appliance.
•
For added protection of the device during a thunderstorm, or when it is left unattended and unused for long
periods of time, unplug it from the wall outlet and disconnect the cable system. This will prevent damage to
the appliance due to lightning and power-line surges.
•
Never push objects of any kind into the appliance through openings as they may touch dangerous voltage
EN
points or short-circuit parts that could result in a fire or electric shock. Never spill liquids of any kind on the
appliance.
•
Do not attempt to service the appliance yourself as opening or removing covers may expose you to dange-
rous voltage or other hazards. Refer all servicing to qualified service personnel.
•
When spare parts are required, be sure the service technician has used replacement parts specified by the
manufacturer or that the spare parts have the same specifications as the original parts. Unauthorized substi-
tutions may result in fire, electric shock or other hazards.
•
Keep away from heat sources such as radiators, heat registers, stoves or other appliances (including ampli-
fiers) that produce heat.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
CHANNEL CONTROL SECTION:
1. GAIN control: Adjustment of the input signal level for
channel 1 & 2
2. TREBLE control: Adjustment of the high frequencies
for channel 1 & 2
3. BASS control: Adjustment of the low frequencies for
channel 1 & 2
4. MIC volume control:
5. HEADPHONE volume control
6. MASTER volume control
7. Crossfader: Set the crossfader to the left side to mute
the LINE 2 input signal or move the crossfader to the
right side to mute the LINE 1 input signal. If the cross-
fader is in the middle position, both LINE 1 input signal
& Line 2 input signal will be mixed and sent to OUTPUT
Jacks
8. POWER LED: Lights up when the unit is powered.
2
Manual - MIX500
2-CHANNEL MIXER
INSTRUCTION MANUAL
© Lotronic 2020
1
2
8
3
4
1
2
3
5
6
7