ERMILA 1870 Li+ Instrucciones De Uso página 13

Máquina de corte de pelo con alimentación de red/por batería

Ocultar thumbs Ver también para 1870 Li+:

Idiomas disponibles

· For a long-lasting, good cutting performance, it is important to oil the blade set fre-

quently (Fig. 8). Only use blade set oil order no. 1854-7935 (200 ml).

· Blade set oil and hygienic spray is available from your dealer or our Service Centre.

· If the cutting performance deteriorates after long use despite regular cleaning and oiling, the

blade set should be replaced.

Automatic Sensor System

To ensure that your new hair cutting appliance enjoys a long service life, the appliance needs to be

cleaned and oiled on a regular basis (see section Cleaning and Care in the user instructions). To

give you advance notice of an urgent need for maintenance care, your hair cutting appliance has

been equipped with an automatic sensor system. This system automatically recognises when the

blade set needs oiling or cleaning. Consistent heavy soiling or lack of oil can lead to early wear

and tear of the appliance.

Should the sensor system recognise such a situation, the appliance switches off, an acoustic

signal will sound and the LCD display will blink for 8 seconds. The acoustic signal and the blinking

of the LCD display can be cancelled by briefly switching the appliance on and off. Before using the

appliance again, it is urgently recommended to clean the appliance and oil the blade set. For this

purpose, please proceed as follows (failure to observe these instructions may result in damage to

and early failure of the appliance. Moreover, all guarantee claims will become void):

· Switch off the appliance using the on/off switch (Fig. 2ⓑ).

· Remove the attachment comb and the blade set and use the cleaning brush to clean the open-

ing of the housing and the blade set. (Fig. 7).

· Oil the blade set (Fig. 8).

Changing the blade set

· Switch off the appliance using the on/off switch (Fig. 2ⓑ).

· The blade set can be removed by sliding it away from the housing in the direction of the

arrow (Fig. 6ⓐ).

· Replace the blade set by hooking it into the housing and pressing it down until it clicks into

position (Fig. 6ⓑ).

Disposal in EU countries

Do not dispose of the appliance with domestic refuse. As part of the EU Directive govern-

ing the disposal of electrical and electronic equipment, the appliance is accepted free of

charge by local waste collection points or recycling centres. Discharge batteries prior to

disposal! Correct disposal will ensure environmental protection and prevent any poten-

tially harmful impacts on people and the environment.

ENGLISH