Connecting The Antenna Signal To Them Egaview20 M Odulator - Marmitek M EGAVIEW20 Modo De Empleo

All manuals and user guides at all-guides.com
A/V appliance via SCART t o TV (3)
The 'SCART OUT' connection on your M egaView 20 offers you the
possibility to connect not only the signal of your A/V devices to the antenna
signal, but to also loop it to a TV set via SCART (for instance for TV sets
that are not connected to your antenna netw ork).
SCART OUT
Attention: This connection only transfers the A/V signal of the
connected device back to the TV set and not the other TV
channels.
4. CONNECTING THE ANTENNA SIGNAL TO THE
M EGAVIEW20 M ODULATOR
Follow the description below to connect the antenna cable.
Connect ing an ant enna cable (4)
Connect the existing antenna cable to the 'ANT/RF IN' connector of the
M egaView 20. Depending on the current situation you may need to
disconnect some of the cables before you can connect the antenna.
Connect ing an ant enna cable t o TV (5)
Connect the 'To TV/ RF OUT' of the M egaView 20 to the antenna port of
the television set (if necessary w ith the use of included antenna cable).
If you w ant to w atch this signal at multiple places, you connect a splitter
betw een the M egaView 20 and the TV (your supplier of antenna materials
can advice you in this). On every television connected to the antenna
6
4
ANT/RF IN
3
5
ToTV/RF OUT
© M ARM ITEK