Perel BB100300 Manual Del Usuario página 7

G
H
Required tools (not included)
5. Assembly
 Do not modify the appliance when assembling it. It is very dangerous and not allowed to
alter parts of the appliance.
 The user is responsible for the correct assembly of the appliance. Damages caused by
improper assembly are not covered by the warranty.
 The barbecue has to be installed on a secure level base prior to use.
 Assemble the appliance according to the illustrations on page 3.
Refer to the illustrations on page 3 of this manual.
6. Use
Fuel
 Always light your appliance with traditional charcoal, never with briquettes. Once the
appliance is lit, you can add briquettes. Use good quality charcoal to light the appliance,
preferably complying with EN 1860-2. Good quality charcoal is composed of large, shiny
bricks and does not give off much dust.
 Do not overfill the bowl. Maximum 50 % of the bowl can be filled with charcoal. Overfilling
the bowl can seriously damage your barbecue due to extensive heat.
Lighting
The barbecue shall be heated up and the fuel kept red for at least 30 minutes prior to first
cooking. This removes any remaining manufacturing greases from the appliance.
Do not put the grill on the appliance yet. An empty grill can deform when held in the heat for
too long.
WARNING! Do not use spirit or petrol for lighting or re-lighting! Use only firelighters complying
to EN 1860-3!
1. Put some firelighters on the bottom of the bowl. Always use firelighters that comply with
EN 1860-3.
2. Cover the firelighters with charcoal.
Do not use too much charcoal. The bowl should only be filled one third.
o
Make sure you can reach the firelighters.
o
V. 02 – 07/11/2018
BB100300
2 M8 plastic washer
2
10 mm wrench
M8 nut
Philips screwdriver
7 ©Velleman nv