Cleaning And Maintenance - Aerian AFP40IX Manual Del Usuario

Make sure that the holes in both guards are aligned
and fasten them securely by using the provided
screw and nut. Once the guard is in position fasten
the clips to finally secure both guards.
OPERATION
1.Place the fan on a stable, level surface.
2.Plug the fan in the mains socket.
3.Set the control knob to select the desired speed. To turn off the
fan, set the control knob to the 0 position.
0= Off 1= Low speed 2=Medium speed 3=High speed
4.To make the fan oscillate, push down the oscillation knob
located on the top of the motor housing and the fan will oscillate
from side to side. To stop the fan from oscillating, lift up the
oscillation knob.
,
5.Tilting Adjustment
Loosen the adjusting knob to
adjust the fan head to the
desired position and then
tighten the adjusting knob.

CLEANING AND MAINTENANCE

Always unplug the fan from the mains socket before cleaning.
Once the fan is assembled, it is forbidden to disassemble the
grids (guard) when cleaning.
Clean the fan with a slightly damp cloth, and then dry it.
Do not immerse the motor housing in water or any other liquid.
Do not use chemical or abrasive cleaner.
EN-5