MENSA HEATING STATIO Guia Del Usuario página 52

- If the power cord needs replacing, it must only be done by a qualified electrician
or the manufacturer to avoid any danger.
- Always unplug the product when not in use.
- Do not use a tablecloth that goes more than 5 cm over the table edge.
- Always pull the power cord and serial connector cords so that it is away from
traffic areas, and never under rugs or similar hedging, so it is not a tripping hazard.
- This product is installed with an overheat sensor, which will turn the product off, if
the product get to hot. If the overheat sensor is activated, immediately unplug the
product and inspect for any foreign objects or whether the product is obscured in
any way, which is the reason for the overheat sensor to activate.
Installation instructions
1
AUS/NZ
Remove the table leg from the box and place it as shown in the picture.. Remove
the transport protection by loosening the three screws. Then remove the top
bracket and install it with the 3 screws and washers.*
All manuals and user guides at all-guides.com