Beper 70.401 Manual De Instrucciones página 7

EN
Humidifier and Aroma Diffuser Use instructions
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
Description of product Fig.A
1. Nebulizer (inside the main housing)
2. Water level float (inside the main housing)
3. Water tank
4. Water tank lid
5. Mist output nozzle
6. Mist output adjustment knob
7. Atomizing tower
8. Atomizing ring
9. LED light ON/OFF switch (at the back)
Operation
Remove the lid from the top of the tank. Fill the tank with tap water, making sure not to fill pass the tip of the
atomizing tower.
If needed, add 3-5 drops of essential oil into the water. Place the lid back on the top of water tank.
Plug in and turn on the appliance by turning the mist adjustment knob.
You can turn on/off the LED light by pressing the ON/OFF switch at the back of the appliance.
Warning: Do not fill the water tank beyond the tip of the atomizing tower.
It is not recommended to set the mist output at a maximum level as soon as the appliance is turned on, because
the mist output can condensate fast, causing the surrounding surface to get wet.
At first, set the mist output to medium intensity and adjust later on to the desired mist output.
The humidifier is equipped with a safety system that turns the appliance off before it runs completely out of wa-
ter, thanks to the water level float. When the water level is low, the red LED light will turn on. This safety feature
prevents the humidifier from being damaged due to lack of water.
To resume operation, simply turn it off by turning the mist adjustment knob, refill the water tank with fresh water
and place the lid back on the main housing. Turn the mist adjustment knob to start the appliance again.
Never remove the mist output nozzle from the lid during operation.
Cleaning and maintenance
Before any cleaning operation, switch the appliance off and unplug it.
Always unplug the unit before cleaning. Remove the atomizing ring and the atomizing tower from the water tank.
Apart from the electrical controls and when the unit is off, any part of the humidifier can be wiped with a soft damp
cloth and buffed with a dry cloth, ensuring the unit is unplugged.
There may be some mineral deposits inside the tank, especially if the water used is particularly hard. In time,
these mineral deposits will affect the affect the operation of the humidifier. It is thus advisable to proceed as
follows at least twice a week:
Dampen a cloth with white vinegar and wipe the nebulizer gently, until the mineral deposits disappear.
Wipe thoroughly with a dry cloth to remove any drops.
7