Installing And Removing The Battery Pack; Battery Storage - Craftsman 98820 Manual Del Usuario

inStalling and reMOVing the
battery pack
Warning:
sAFeTy key Is Removed To
PReveNT ACTUATIoN BeFoRe
RemovINg oR INsTALLINg BATTeRy.
tO inStall battery pack:
• depress the battery port cover release
button (14) and pull the battery port cover
(15) up to expose the battery port (10) as
shown in figure B.
• Slide the battery (16) into the battery
port until it is fully seated and an audible
click is heard (figure c). Make sure
battery pack is fully seated and fully
latched into position.
• Close the battery port cover. Ensure the
cover is fully latched before starting mower.
B
C
tO reMOVe battery pack:
• Open the battery port cover (15) as
described above.
• depress the battery release button (17) on
the battery pack and pull battery pack out
of tool as shown in figure d.
d
mAke CeRTAIN THe
15
14
16
17
battery StOrage
An extra battery can be stored using the
battery storage compartment (11).
• Lift the storage compartment cover and
slide the battery into the compartment
as shown in figure e. battery in this
compartment will not actuate the mower.
E
aSSeMbly
WARNING:
sure the bail handle is released and the
safety key is removed.
attaching lOWer handle
• lift lower handle (4) into place making
sure the arrow (18) on the base of the
mower lines up with 1 or 2 on the base of
the handle (19) (inset of figure f)
CAUTION:
Ensure each side of the lower
handle is set on the same number. The arrow
must be lined up with 1 or 2 for operation.
• Close the handle height adjust levers
(7) as shown in figure f. As you close
each, make sure the teeth are engaged
as shown in figure g.
• If the connection between the handle
and lever is too tight or loose, open the
lever and adjust the depth of the lever
by turning the lever. close it again until
the teeth are fully clasped and each
lever stays securely closed.
f
4
18 19
g
9
before assembly, make
7