Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
M4 × 10 mm screws
Step 5: Attach the base covers and lower arm.
Step A: Slide the top and bottom base covers onto the base until they snap into place.
Step B: Slide the lower arm onto the base.
Step C: Slide the upper arm over the lower arm, then insert the bracket cover into the top of the
upper arm. The cover should snap into place.
NOTE: To remove the bracket cover, use a fl athead screwdriver to pry off the cover.
OR
Caution: The upper arm is under tension and will move
up rapidly, on its own, as soon as the attached monitor is
removed. For this reason, remove the upper arm, lay the
monitor face down on a soft surface, then remove the monitor.
Failure to follow this instruction may result in serious personal
injury or equipment damage.
M4 × 10 mm knobs
11
Publicidad
Tabla de contenido
