rolled back automatically onto the installed cable drum and disappear completely into
the device up to the plug.
4. The floor nozzle can be kept attached to the vacuum cleaner for ease of storage after
use.
The cyclone vacuum cleaner function without needing a dust bag. The sucked up dirt is
forced into the dust container by force of the air jet instead. The air is cleaned by a
washable permanent filter (HEPA filter) in the dust container, motor protection filter and
an exhaust air filter.
Caution!
Never vacuum clean without a filter or with a damaged filter. The dust that is
sucked up would force its way into the device and damage the motor.
Clean dust / dirt in the dust container by an entirely new method ---it's simple, clean
and so easy.
Emptying dust container
You can easily see with the transparent dust container when
it must be emptied.
1. Switch off the vacuum cleaner and disconnect the plug
from the mains. To do this always pull on the plug and
not on the cable.
2. You can pull the dust container together with the cleaning
system out of their anchoring with the aid of the carrier
handle on the dust container. Now lift out the dust
container and carry it to the waste bin.
3. A push button is located on the dust container that you can
use to open and empty it automatically (bottom-down
technology). To do this hold the dust container over your
dustbin and press on the empty button.
4. After emptying it clean the HEPA filter again if necessary
(see also Cleaning the HEPA filter below). After this rinse
out the dust container and wipe it dry.
Important!
When the dust container is full, it is sensible to pull a plastic bag over it and to
empty it into this bag. This prevents the spilling of dust.
5. After this push the HEPA filter cleaning system back into position in the cyclone
vacuum cleaner until it snaps into place. Your cyclone vacuum cleaner is now ready
for use again.
All manuals and user guides at all-guides.com
HEPA FILTER CLEANING SYSTEM
- 12 -