Cleaning The Hepa Filter; Motor Protection Filter; Cleaning The Exhaust Air Filter - AIRIS ASP01S Manual Del Usuario

Cleaning the HEPA filter

The HEPA filter and the HEPA cover should be cleaned regularly. Cleaning is best done
when emptying the dust container. To do this follow the instructions in the Emptying dust
container section.
1. Switch off the vacuum cleaner and disconnect the plug from the mains. To do this
always pull on the plug and not on the cable.
2. You can pull the dust container together with the cleaning system out of their anchoring
with the aid of the carrier handle on the dust container. Take hold of the carrier handle
on the dust container and pull it upwards. Now pull the dust container out and loosen
the HEPA cover and HEPA filter out of the dust container with the aid of the lateral
unlocking button.
3. Turn the dust container cover carefully until it is released and the HEPA filter will come
away easily
4. Now rinse the HEPA filter under running water and allow it to dry.
Caution!
Only ever clean the filter with clean water and do not use soap or detergent. These
would destroy the filter.
5. Place the HEPA filter back in the HEPA cover (or replace with a new one) and fit it into
the dust container. Then fit the dust container back into position in the cyclone dust
container until it snaps into place. Your cyclone vacuum cleaner is now ready for use
again.

Motor protection filter

The motor protection filter cleans the air that is sucked in before
it enters the motor. The air is cleaned of fine dusts, mites,
bacteria and viruses. This prevents dirt or dust particles from
getting into the motor or the surrounding air.

Cleaning the exhaust air filter

The exhaust air filter cleans the air a final time before it leaves
the vacuum cleaner. You can clean the exhaust air filter as follows:
1. Switch off the vacuum cleaner and disconnect the plug from
the mains. To do this always pull on the plug and not on the cable.
2. Open the exhaust air grill (this is at the rear of the cyclone vacuum cleaner.)
3. The exhaust air filter is visible when the grill has been opened.
4. Rinse the filter under cold running water and allow dry.
Caution!
Only ever clean the filter with clean water and do not use soap or detergent.
These would destroy the filter.
5. Put the exhaust air filter back into place (or replace with a new one) and place in the
grill.
6. Close the exhaust air filter grill.
All manuals and user guides at all-guides.com
- 13 -