Introduction; Main Features; Technical Specifications - O&O LOG-BC Manual De Instalación

The control unit denominated LOG-BC is designed to manage the PRIVEE automation and is equipped with encoder input for
learning the stroke and recognising the obstacle.
Thanks to the considerable amount of logic available even very particular operating conditions on sytems can be met.
- Microprocessor logic
- Green LEDS displaying the status of the NO control inputs and red LEDS for the status of the NC safety ones
- Pull out terminal blocks
- Output for a flashing light and gate open indicator or for a red and green traffic light
- Integrated radio receiver 433Mhz; 2048 codes
DL1
PM1
PM2
START
AP.PD
PM3
SW3
M3
All manuals and user guides at all-guides.com
LOG-BC
Installation and operation manual

1. INTRODUCTION

2. MAIN FEATURES

CHIUDE
PR2 PR1
APRE
AP.PD.
START
P
STOP
FOTO
ENC
COSTA
OUT 2
PWR
OUT 1
F2

3. TECHNICAL SPECIFICATIONS

- Power:
- SCA output:
- Flashing lamp output
- Power supply output for
accessories
M2
M1:
M2:
M3:
SW3: 8-way Dip Switch
F2:
AP.PD: Semi-automatic opening cycle
START: Start and programming
PM1:
PM2:
PM3:
µP:
M1
230Vac ±10% 50/60 Hz 100W
24Vac 3 W
24Vac 25Wmax
20 ÷ 26 Vac 12W max.
- 11 -
Power terminal board
Controls and safety devices terminal board
Motor terminal, transformer, +acc
Power fuse 500mA 5x20
Pre-manoeuvre warning lamp flash time
Chain dip
Pause time
Microprocessor with flash memory
EN