Mx Onda MX-PM2780 Manual De Instrucciones página 22

USE OF POPCORN MACHINE
1. Insert the plug on the power cord into an electrical outlet of 230 V, provided
grounding.
2. Check that the kettle is properly seated in the stands, which is upright and
coupled gears.
3. Turn on the popcorn machine using the switch on / off 1 and wait 3 to 5
minutes to preheat the kettle. Once the kettle is hot, turn off the popcorn
machine using the switch on / off 1.
4. With caution to avoid burns, open the lid of the kettle by the handle 4,
and by measuring spoon 9 pour oil inside the kettle a measure of oil (about
3/4 measuring spoon). This measure may vary depending on the user's
taste.
5. Complete measuring spoon 8 corn kernels and insert them into the kettle.
IMPORTANT: Never add less or more grains of corn than will fit in the
dosing pot. If you add fewer, popcorn will too oily and if you add more
quantity than will fit in the dosing pot, popcorn not have the right taste and
can burn.
6. Once poured the corn kernels and oil into the kettle, then close the lid by
the handle 4.
7. Close the liftgate 6 and then close the front door. If you do not close the
doors, it may happen that popcorn are expelled outward.
8. Press the switch on / off 1 and the popcorn machine will become working
after a few minutes begin to jump into the reservoir 7 popcorn machine
popcorn.
The remover system incorporating the kettle, mix the oil with corn kernels
and prevents burning corn kernels.
9. When you notice that no longer jump over popcorn, turn off the popcorn
machine by switch on/off 1. Open the front door by the handle switch and
the trough 3, tilt the kettle to empty popcorn that may get inside the kettle.
10. Repeat steps 4 to 9 as many times as necessary to prepare the desired
amount of popcorn.
11. Serve popcorn according to your preferences, as they leave the machine or
add salt, pepper, sugar, candy, etc.
INSIDE LIGHT
To turn on or off the inside light, press the switch on / off of 2.
All manuals and user guides at all-guides.com
6