Wagen Tech 7406 Manual Del Usuario página 11

All manuals and user guides at all-guides.com
the Battery recondition LED will light. When the light is off, that means battery
reconditioning is completed. The charger will automatically return to charge
mode.
Charging Time
Charging time may vary depending on multiple factors:
Battery State – Depending on the voltage of your battery, it may take up to 10
hours to charge. Batteries with higher voltage can usually be charged in a few
hours.
Battery Rating – A higher rated battery will take longer to charge than a lower
rated battery under the same conditions. A battery is rated in ampere-hours (Ah),
reserve capacity (RC) and cold-cranking amps (CCA).
Charge Rate – The charge rate is measured in amps. A battery charged at a
lower rate will take longer than a battery charged at a higher rate. However,
smaller batteries can be easily damaged by charging at a rate which is too high
for the capacity of the battery.
Temperature – Cold temperature will affect a battery's ability to accept a charge.
Charging in cold temperatures will increase the amount of time required to
charge a battery.
Charging Display
The digital display can show three types of information. By pressing the button,
you can toggle between them.
Current – the charging current (A) will be displayed.
Voltage – the charging voltage (V) will be displayed.
Note: The voltage displayed is the charging voltage and usually will be higher
than the battery's resting voltage.
Battery Capacity % – the real-time battery capacity will be displayed.
1. Displays "LO" when battery capacity less than 60%
2. Displays "60%-70%-80%-90%" when battery voltage goes up gradually
3. Displays "FUL" when charger goes into float charge mode
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
©2020 Wagan Corporation. All Rights Reserved.
8