Tabla de contenido
Publicidad
All manuals and user guides at all-guides.com
2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 27)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Black)
(39-pin IDE1, see p.2 No. 36)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATA2 Connectors
(SATAII_1 (PORT 0): see p.2, No. 20)
(SATAII_2 (PORT 1): see p.2, No. 19)
(SATAII_3 (PORT 2): see p.2, No. 18)
(SATAII_4 (PORT 3): see p.2, No. 17)
(SATAII_5 (PORT 4): see p.2, No. 16)
(SATAII_6 (PORT 5): see p.2, No. 15)
Serial ATA3 Connectors
(SATA3_1 (PORT 6): see p.2, No. 11)
(SATA3_2 (PORT 7): see p.2, No. 9)
ASRock 980DE3/U3S3 Motherboard
the red-striped side to Pin1
connect the black end
to the IDE devices
These six Serial ATA2 (SATA2)
SATAII_6
connectors support SATA data
(PORT 5)
cables for internal storage
devices. The current SATA2
SATAII_5
interface allows up to 3.0 Gb/s
(PORT 4)
data transfer rate.
SATAII_2
SATAII_4
(PORT 1)
(PORT 3)
SATAII_1
SATAII_3
(PORT 0)
(PORT 2)
These two Serial ATA3
SATA3_2
(SATA3) connectors support
(PORT 7)
SATA data cables for internal
storage devices. The current
SATA3_1
SATA3 interface allows up to
(PORT 6)
6.0 Gb/s data transfer rate.
17
Publicidad
Tabla de contenido
