ASROCK 980DE3/U3S3 Manual Del Usuario página 20

All manuals and user guides at all-guides.com
The front panel design may differ by chassis. A front panel module
mainly consists of power switch, reset switch, power LED, hard drive
activity LED, speaker and etc. When connecting your chassis front
panel module to this header, make sure the wire assignments and the
pin assign-ments are matched correctly.
Chassis Speaker Header
(4-pin SPEAKER 1)
(see p.2 No. 26)
Power LED Header
(3-pin PLED1)
(see p.2 No. 25)
Chassis and Power Fan Connectors
(4-pin CHA_FAN1)
(see p.2 No. 12)
(4-pin PWR_FAN1)
(see p.2 No. 2)
CPU Fan Connectors
CPU_FAN_SPEED
(4-pin CPU_FAN1)
(see p.2 No. 3)
Though this motherboard provides 4-Pin CPU fan (Quiet Fan) support, the 3-Pin
CPU fan still can work successfully even without the fan speed control function.
If you plan to connect the 3-Pin CPU fan to the CPU fan connector on this
motherboard, please connect it to Pin 1-3.
20
ASRock 980DE3/U3S3 Motherboard
Please connect the chassis
speaker to this header.
Please connect the chassis
1
power LED to this header to
PLED-
PLED+
indicate system power status.
PLED+
The LED is on when the system
is operating. The LED keeps
blinking in S1 state. The LED is
off in S3/S4 state or S5 state
(power off).
Please connect the fan cables
to the fan connectors and
match the black wire to the
ground pin.
Please connect the CPU fan
FAN_SPEED_CONTROL
cable to the connector and
+12V
match the black wire to the
GND
ground pin.
1 2 3 4
Pin 1-3 Connected
3-Pin Fan Installation