Mitsubishi Electric Jet Towel JT-SB216JSH-W-NE Manual De Instalación página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45
Installation (Continued)
Warning
Use single-phase 220-240V power.
Using the incorrect power supply may cause fi res, electric shocks or
malfunctions.
Wire it to the terminal block. (No polarity)
1. Remove 12mm (single wire) or 8mm
(stranded wire) of wire sheath from the
end.
2. Screw the power cable to the terminal block.
Proper torque is 1.2N·m(11 lbf·in)
Terminal
block
5
Screw
3. Check that the power cable is securely fi xed
to the terminal block.
4. Wire the ground wire to the center terminal
of the terminal block.
Proper torque is 1.2N·m(11 lbf·in)
5. Clip and screw the power cable into the
position shown on the right.
Power cable
− 8 −
12
Single wire
Stranded wire
Insulated ring
tongue terminal
Power
cable
Terminal
block
Screw
Ground wire
Power cable hole
Power cable
Cord clip
(Included)
Mounting
screw
Unit (mm)
70
65
8
Terminal
block
Cord clip mounting screw hole

Publicidad

Tabla de contenido
loading

Tabla de contenido