Publicidad
Idiomas disponibles
Idiomas disponibles
Mobile App Interface
⚫
In Control tap, Room Temperature, Floor
temperature, Current setpoint, next setpoint
(next program)will be displayed.
⚫
Press Power key to turn on or off the
thermostat.
⚫
Press + or – to adjust the current setpoint to
override the program. The button turns green.
⚫
Press the "override program" button to
release the override or the override setpoint
would be released in next program time slot.
⚫
The history show the Temperature history. In
1day / 1week / 1month.
⚫
In Programs tap, current program mode will be
displayed. ( No Program / 1Day / 1+5+1 /
7days).
⚫
When No Program is selected, no setting can
be adjusted.
⚫
When 1Day / 1+5+1 / 7Day program is
selected. Program time slot and setpoint can
be adjusted.
⚫
In Setting Tap, Internal setting can be
adjusted.
⚫
Internal Sensor / External Sensor / Combined
sensor can be selected when it is in heat
mode.
⚫
Only Internal Sensor will be used when it is in
cool mode.
⚫
Temperature offset is adjusted only when there
is difference between the actual temperature
and the measured value from thermostat .
⚫
Thermostat clock will be synchronized when
"Sync" is pressed.
Controller LCD Interface
Turn On/Off the thermostat
Press-n-Hold on [On/Off Key] to turn On / Off the
thermostat. When the thermostat is Off. No
Output will be activated.
Clock setting
**Normally the clock is automatically set once wifi
is connected and synchronize for each day. So
manual set is not necessary when it is online.
Press [CLOCK] to start the setting
Press [▲] / [▼] to change the day of week
Press [CLOCK] again to confirm day of week setting
and start to adjust hour
Press [▲] / [▼] to change the hour
Press [CLOCK] again to confirm hour setting and
start to adjust minutes
Press [▲] / [▼] to change the minutes
Press [CLOCK] again to confirm minutes setting and
start to adjust day of week
Press [blank] to confirm or leave the clock setting. Or
return after no key pressed for 20 seconds.
Clock synchronization
Controller syncs local time when it has access to the
internet. Please make sure it stays connected.
If you wish to sync network clock manually, press the
button on the App
Schedule Programming
When 1 day / 5+1+1 day / 7day program is selected
in internal setting.
⚫
Press-n-Hold on [Clock] to start the setting
⚫
Press [▲] / [▼] to adjust the day of week
⚫
Press [Clock] to confirm
⚫
Press [▲] / [▼] to adjust the time of schedule
⚫
Press [Clock] to confirm
⚫
Press [▲] / [▼] to adjust the setpoint
⚫
Press [Clock] to confirm
⚫
Press [Blank] to confirm and exit
Override Temperature
The Set point can be adjusted by [▲] / [▼].
When it is in program mode, The set point will be
overridden until the next time slot.. [Clock] can be
pressed to release the override status.
Publicidad
