Cleaning Accessories; Instructions Of Use; Maintenance And Cleaning - Jata AP910 Instrucciones De Uso

Aspirador con bolsa clase a
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
•  Do not leave unattended while in use.
•  Do not use if the cable is deteriorated.
•  Do not use to vacuum any liquids, water, petrol, etc.
•  Unplug from the mains after using the appliance.
•  Take care when vacuum on the stairs.
•  This appliance is designed for domestic use only.
•  The cleaning and maintenance done by users, can not be done by 
children without any supervision.
•  If the cable were to deteriorate it must be changed by an 
Authorised Service Centre.

CLEANING ACCESSORIES

Floor brush. (16)
• For all type of floors. Can be used with or without brush depending on the surface you are going to clean.
• Press the key of the brush backwards. This position is for wood floor, parquets, tile, etc. For carpet and similar
press upwards the key.
Crevice nozzle with brush (17).
• For hard to reach areas, nooks, seals, windows.
• You can use it with or without the brush. To do it, rotate as shown in Figure 1.
• This nozzle can be fixed to the telescopic tube with the anchorage (18). To do this place the anchor on larger
diameter side in the tabs that are found in the front side of the manual absorption regulator (13).

INSTRUCTIONS OF USE

• Before using the vacuum cleaner prepare the accessories which correspond to the surface you are going to
clean.
• Check that the bag is properly placed.
• Place the hose (9) in the anchor (7), matching the tabs into the holes and turn clockwise. Place the telescopic
tube (14) at the end of the hose and then the accessory you want.
• You may adjust the length of the telescopic tube sliding upwards the regulator (15).
• All the accessories are put on by pressure.
• Plug the appliance to the mains. To do so remove the cable (8), never take out the cable further than the color
marking which indicate the end of the cable.
• Press the start button (1).
• You can adjust the power by opening or closing the manual regulator (13) placed in the handle of the flexible
tube.
• If you are working with the floor brush (16) you can store it in the accessories support placed in the back side of
the vacuum cleaner.
• Once the work is finished switch off the appliance by pressing the pusher (1) unplug it from the mains and put
the cable away by pressing the pusher (2). It is advisable to hold the plug in your hand to avoid it hitting the body
of the vacuum cleaner.
• To remove the hose (9) from the anchor (7) turn it counter clockwise and remove it.

MAINTENANCE AND CLEANING

• Before you proceed to cleaning disconnect the appliance from the mains.
• Clean the outside with a dry cloth.
• Do not use abrasive or chemical products, such as metallic scourers, which may deteriorate the surfaces of the
appliance.
Changing the bag
• Remove the bag when the bag full indicator (6) turns red.
9

Publicidad

Tabla de contenido
loading

Productos relacionados para Jata AP910

Tabla de contenido