Descargar Imprimir esta página

Helvex LAV MARCUS BC W Guia De Instalacion página 2

Publicidad

Instalación General / General Installation
Instalación General / General Installation
Coloque el lavabo y marque el
2
contorno sobre la cubierta.
sink and mark the outline on the cover.
Instalación en Madera
/ Wood Installation
Coloque las anclas y enrosque las
5
pijas (incluidas) para fijar el labavo.
Place the anchors and screw the lags
(included) to fix the sink.
rebosadero
/ overflow
Nota: Ubicar la posición del lavabo con el rebosadero opuesto a la
mezcladora o monomando.
Note: Place the basin with the overflow hole opposite to your faucet
positon.
Posibles Causas y Soluciones / Troubleshooting
Problema
/ Problem
El agua no se por el rebosadero.
/ The water doesn´t go down the overflow.
Los líquidos se quedan estancados.
/ Liquids stay stagnant.
Participa en nuestros
cursos gratuitos
de capacitación.
Enter our free
training courses.
Recomendaciones de Limpieza / Cleaning Recommendations
Es muy importante seguir las siguientes instrucciones para conservar los
acabados de los productos HELVEX, con brillo y en perfecto estado:
1. Utilice únicamente agua y un paño limpio.
2. No utilice fibras, polvos, abrasivos, ni productos químicos.
3. No utilice objetos punzo-cortantes para limpiar los acabados.
4. Se recomienda realizar la limpieza de su producto diariamente.
Nota: Vea nuestros tips en la pag. www.helvex.com.mx
HELVEX, S. A. DE C.V. Calzada Coltongo 293, Col. Industrial Vallejo 02300 Del. Azcapotzalco, México, D.F . T el. (55) 53-33-94-00.
/ Drain Installation
/ Drain Installation
Trace una línea a 5,08 cm de
3
/ Place the
separación hacia el interior y realice el
corte en la placa o base
2" apart inwards and make the cut on
the plate or base..
contorno exterior
del lavabo /
outer
contour of the basin
Instalación en Mármol
Por la parte inferior de la placa o base
6
/
perfore con broca de 3/8" hasta ½"de
profundidad e introduzca el inserto de
latón colocando adhesivo epóxico (no
incluido) al fondo de la
the bottom of the base or plate drill with
3/8" drill bit up to ½" deep and insert the
brass screw insert adding epoxy
adhesive (not included) to the bottom of
the hole.
inserto de latón
/ brass insert
Se instaló una contra sin rebosadero.
/ A drain stopper without overflow was installed.
Algún objeto se encuantra obstruyendo el céspol o el rebosadero.
/ Some object is obstructing the trap or overflow.
Comunícate:
Contact:
En la Ciudad de México:
In Mexico City:
01 55 53 33 94 00
Ext. 5804, 5805 y 5806
.
/
Draw a line
m
5 , 0 8 c
( 2 , 0 " )
línea de corte
cut line
/ Marmol Installation
perforación./ On
Causas
/ Causes
En Monterrey:
In Monterrey:
(0181) 83 33 57 67
(0181) 83 33 61 78
It is very important to follow the instructions below to preserve HELVEX products
finishes, shiny and in perfect condition:
1. Use only water and a clean cloth.
2. Do not use fibers, powders, abrasives, or chemicals.
3. Do not use sharp objects to clean the finish.
4. It is recommended to clean your product daily.
Note: See our tips on: www.helvex.com.mx
Por la parte inferior de la placa o base,
4
marque los centros para las pijas o
insertos de latón.
/ On the bottom of
base or plate, mark the centers for the
lags or brass inserts.
Aplique el sellador adhesivo a la ceja
7
del lavabo después coloque el lavabo
en posición con las anclas y enrosque
los tornillos (incluidos) para fijar el
labavo.
/ Apply adhesive sealant to the
flange basin, then place it with anchors
and and tighten the screws (included) to
fix the sink.
sellador adhesivo
/ adhesive sealant
Soluciones
Coloque una contra con rebosadero.
/ Install a drain stopper with overflow.
Retire el elemento obstructor.
/ Remove the obstructing object.
En Guadalajara:
In Guadalajara:
(0133) 36 19 01 13
/ Solutions
2

Publicidad

loading

Este manual también es adecuado para:

Lav marcus bc b