Before You Start; Installing And Replacing The Batteries - Terraillon TMB-988 Manual De Instrucciones

BEFORE YOU START

Installing and Replacing the Batteries

• 2×AAA batteries (Not Included)
• Open the battery cover
• Install the batteries by matching the correct polarity, as shown
• Replace the cover
Replace the batteries whenever the below happen
• The
CAUTION
Remove batteries if the device is not likely to be used for some time. The old batteries are harmful to the
environment; do not dispose with other daily trash. Remove the old batteries from the device and follow
your local recycling guidelines. Do not dispose of batteries in fire. Batteries may explode or leak.
Setting Date, Time and Measurement Unit
It is important to set the clock before using your blood pressure monitor, so that a time stamp can
nt
be assigned to each record that is stored in the memory.
1. When the monitor is off, hold pressing "SET" button for 3 seconds to enter the mode for year setting.
Or when the monitor is off, press "SET" button shortly, it will display the time. Then hold pressing "SET"
button to enter the mode for year setting. Note: "MEM" button allows you to change the data, "SET"
button allows you to confirm the data.
2. Press "MEM" button to change the [DAY].
3. When you get the right day, press "SET" button to set down and turn to next step.
4. Repeat steps 2 and 3 to set the [MONTH] and [YEAR].
5. Then the monitor diverts to time setting. Select the time format. Repeat steps 2 and 3 to confirm the time
format, between 12h and 24h.
6. Repeat steps 2 and 3 to set the [HOUR] and [MINUTE].
7. Repeat steps 2 and 3 to set the [UNIT].
8. After the unit is set, the LCD will display all the settings you have done and then it will turn off.
All manuals and user guides at all-guides.com
BLOOD PRESSURE MONITOR – INSTRUCTION MANUAL
shows • The display dims
EN
• The display does not light up
17